Notice: Undefined variable: position6 in /home/domains2/public_html/ on line 215

Husqvarna 50 chain keeps coming off - Husqvarna Garden

Posted by Anonymous on Apr 12, 2015

★ ★ ★ ★ ☆ 4.0 stars


Product Troubleshooting for Husqvarna

Notice: Undefined variable: position5 in /home/domains2/public_html/ on line 259

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Answers :

If you recently swapped chains did you put on the correct pitch? Normally this saw uses a .325 chain; unless, someone has modified it to use .375 (3/8)
Are you adjusting the chain tension correctly?? Make sure the bar in installed correctly with the tension adjustment pin in the appropriate hole. Elevate the tip of the guide bar while adjusting the chain adjustment screw until the chain is snug but not tight. Then tighten the bar bolts without lowering the tip of the bar. Also ensure the drive links are engaging the sprocket correctly. If the chain is adjusted correctly and the problem still exists, remove the sprocket side cover, bar and chain and inspect the sprocket for extreme wear. Once the sprocket is worn excessively it won't want to engage the drive links of the chain correctly which could be the source of the problem. If so, replace both the sprocket and the chain because the excess wear of the sprocket could have damaged the drive links of the chain and putting an old worn chain back on with a new sprocket will cause the new sprocket to begin wearing prematurely.

Research, Knowledge and Information :

Notice: Undefined variable: position4 in /home/domains2/public_html/ on line 304

Notice: Undefined variable: go_page in /home/domains2/public_html/ on line 315

Product support - My chain is coming off the saw. How can I ...

My chain is coming off the saw. How can I remedy this? There are three main reasons for a chain to come off. 1. ... Do I need to keep my chain properly tensioned ?
Read More At :

I have a Husqvarna 455 Rancher 20" chainsaw. I ... - AnswerArmy

Question I have a Husqvarna 455 Rancher 20" chainsaw. ... and I have always had a problem with the chain coming off the bar. I have to keep ... I have two Husqvarna ...
Read More At :

Husqvarna Lawn tractor. Is my deck belt tension correct ...

I have a Husqvarna lawn tractor YTH22v42LS and the beck belt keeps coming off. ... Tractors > Lawn and Garden Tractors By Brand > Husqvarna/Dixon ... Top 50 | Tractor ...
Read More At :

Husqvarna 445 / loose chain issue...? | Forums Home

Husqvarna 445 / loose chain issue...? ... I dropped my chain off with a buddy last night to run through his ... Is it keeping the chain tensioner screw from coming ...
Read More At :

Chain falls off chainsaw. - JustAnswer

Chain falls off chainsaw. ... I have a chain saw that keeps coming off after 4 to 5 cuts. ... Husqvarna is a better brand than the discount store saws, ...
Read More At :

Why does the chain on my 440E chainsaw keep... . Chainsaws ...

Question Why does the chain on my 440E chainsaw keep falling off ... Im not sure if this is happening after the chain pops off or ... I am Not a Husqvarna ...
Read More At :

Tool-Less Chain Tensioning - Husqvarna Chainsaw - YouTube

Sep 18, 2013 ยท This video shows you how to tension the chain on a Husqvarna 235 ... Tool-Less Chain Tensioning - Husqvarna ... If the chain is too loose it can fall off ...

Husqvarna LGT2654 (54") 26HP Lawn Tractor (2013 Model ...

The Husqvarna lgt2654 (54") 26hp lawn tractor ... Belt keeps jumping off mower deck. ... Checked it out and there was an oil leak coming out of the transmission on ...
Read More At :

Having problems with your Husqvarna ?

Loading ...

Load time: 0.0343 seconds